Power Supply

This section explains the power supply for each component.

Batteries can also be inserted in the portable diversity tuner (URX-P2) in the same manner.

1 Slide the battery-compartment catches inward (in the direction of the arrows b B) to take out the battery holder.

Diversity tuner module (URX- M2)

When incorporated into another component (e.g., MB-X6, SRP-X500P, etc.), the tuner module draws its power from that component.

For details on the power supply to the diversity tuner module, refer to the operating instructions of the component in which the diversity tuner module is installed.

Body-pack transmitter (UTX- B2), hand-held microphone (UTX-H2), plug-on transmitter (UTX-P1), and portable diversity tuner (URX-P2)

These components can be powered by two LR6 (size AA) alkaline batteries. Details on inserting the batteries and the battery condition indication are given below:

Note

The manganese batteries cannot draw sufficient performance from the component. Be sure to use the alkaline batteries.

Inserting the batteries

Body-pack transmitter (UTX- B2)/portable diversity tuner (URX-P2)

The procedure below uses the body-pack transmitter (UTX-B2) in the illustrations.

2 Insert the batteries into the battery compartment by matching their polarities to the indications inside the compartment. Then, set the battery holder in the original position.

Note

Taking out the battery compartment during signal transmission may cause high noise. Be sure to turn off the component before taking out the battery compartment.

Power Supply 35