To install a diversity tuner module (URX-M2) into the optional SRP-X500P Powered Mixer

The SRP-X500P Powered Mixer (not supplied) can accommodate up to two diversity tuner modules (URX-M2).

For details on installation procedure, refer to the Operating Instructions supplied with the SRP- X500P.

Remove the protection panel (large) from the SRP-X500P. Inspect the top and bottom sides of the diversity tuner module and insert it into the slot.

To uninstall the tuner module

Pull the latch securing the tuner module to the side and pull out the tuner module.

Latch

Operation

The procedure below is the same for all UWP series transmitters (UTX-B2/H2/P1) and tuners (URX- P2/M2).

1 Make all necessary connections on the tuner.

For examples of UWP series component connections, see “System Configurations” on page 50.

2 Turn on the tuner.

The parameters that were in the display section when the tuner was last turned off appear again.

Note

Noise will be produced when the tuner is turned on. Before turning on the tuner, turn down the volume of the equipment connected to the tuner.

3 Set the reception channel on the tuner.

Switch the channel on the tuner with the transmitter turned off and select the channel where the RF indicator does not turn on.

For details on setting the reception channel, see “Setting the reception channel” on page 43.

4 Set the transmission channel on the transmitter, and then turn off the unit.

For details on setting the transmission channel, see “Setting the transmission channel” on page 47.

5 Turn on the transmitter.

42 Operation