If noise is heard
Depending on the environment where the UWP series components are installed, external noise or radio waves may disrupt transmission on certain channels.
When selecting a channel under these circumstances, turn off the transmitter. Then, on the tuner, select a channel for which the RF indicator does not light up (i.e., a channel free from noise or radio wave interference). Set the same channel on the transmitter.
Note
To prevent interference or noise, please take the following precautions.
•Do not use two or more transmitters with the same wireless channels.
•When operating two or more UWP series packages simultaneously, set each package to a different channel within the same channel group.
•Keep the reception antenna and the transmitter separated more than 3 meters (9 feet 11 inches).
•When operating two or more UWP series packages simultaneously with different channel groups, make sure that they are at least 100 meters (330 feet) apart, if they are used within clear sight of each other. (The actual distance may differ depending on the circumstances.)
Tuner Settings
Setting the reception channel
The procedure below is the same for all UWP series tuners
Refer to the pdf files “Sony Wireless Microphone System Frequency List” on the supplied
1 Press down the SET button for more than one second.
Keep pressing the SET button until the display section parameters start to flash.
2 Press the SET button repeatedly until the channel group and the channel number indications appear.
The channel group indication starts to flash.
3 Press the + or – button to select the channel group.
Pressing the + button cycles the indication in the order shown in the tables in the pdf files “Sony Wireless Microphone System Frequency List” on the supplied
Tuner Settings 43