qs Ventilation holes (intake)Notes

•Do not place anything near the ventilation holes as it may cause internal heat build-up.

•Do not place your hand or objects near the ventilation holes as it may cause the air coming out heat build-up.

qd Connector panelFor details, see “Connector Panel” on page 11.qf Rear remote control detector (SIRCS receiver)How to open/close the front coverTo open the front coverPress the OPEN button.The front cover is opened and set on the front of the projector.To close the front coverRestore the front cover by hand.

•Do not tilt the projector out of the range of the adjuster setting when you open the front cover. If the projector is tilted too much, the front cover opens speedily or slowly.

•The lamp goes out if the front cover is kept closed while the power is on.
How to use the adjusterTo adjust the height

Adjust the height of the projector as follows: 1 Lift the projector and press the

adjuster adjustment buttons.

Overview

 

The adjusters will extend from the

 

projector.

 

Adjuster adjustment buttons

2 While pressing the buttons, lower the projector. Then, release the buttons. For fine adjustment, turn the adjusters to the right and the left.

to lower the

to raise the

projector

projector

Notes

•Be careful not to let the projector down on your fingers.

•Do not push hard on the top of the projector with the adjusters out. It may be occurred malfunction.

Location and Function of Controls 9 GB