Symptom | Cause and Remedy |
|
|
The image extends beyond | The APA key has been pressed even though there are black edges |
the screen. | around the image. |
| c Display the full image on the screen and press the APA key. |
| c Adjust “Shift” on the INPUT SETTING menu properly. |
|
|
The picture flickers. | “Dot Phase” on the INPUT SETTING menu has not been adjusted |
| properly. |
| c Adjust “Dot Phase” on the INPUT SETTING menu properly. |
|
|
Indicators
Indicators | Status and Remedy |
|
|
The LAMP/COVER | • The lamp cover or the air filter cover is detached. |
indicator flashes in orange. | c Attach the cover securely. |
(Repetition rate of 2 |
|
flashes) |
|
|
|
The LAMP/COVER | • The lamp has reached the end of its life. |
indicator flashes in orange. | c Replace the lamp. |
(Repetition rate of 3 | • The lamp has reached a high temperature. |
flashes) | c Wait for 60 seconds to cool the lamp and then turn on the power |
| again. |
|
|
ON/STANDBY flashes in | • The internal temperature is unusually high. |
red. (Repetition rate of 2 | c Check to see that nothing is blocking the ventilation holes. |
flashes) | • The projector is being used at a high altitude. |
| c Ensure that “High Altitude Mode” in the Setup menu is set to |
| “On.” |
|
|
ON/STANDBY flashes in | The fan is broken. |
red. (Repetition rate of 4 | c Consult with qualified Sony personnel. |
flashes) |
|
|
|
ON/STANDBY flashes in | Unplug the AC power cord from the wall outlet after the ON/ |
red. (Repetition rate of 6 | STANDBY indicator goes out, plug the power cord to the wall |
flashes) | outlet, and then turn the projector on again. If the ON/STANDBY |
| flashes in red and the problem persists, the electrical system has |
| failed. |
| c Consult with qualified Sony personnel. |
|
|
Troubleshooting 13 GB