Although the lamp goes out, the cooling fan keeps running. The power saving mode is canceled when a signal is input or any key is pressed. In power saving mode, any key does not function for the first 60 seconds after the lamp goes out.
•ON/STANDBY: Lights up or flashes under the following conditions:
–Lights in red when a AC power cord is plugged into a wall outlet. Once in standby mode, you can turn on the projector with the I / 1 key.
–Lights in green when the power is turned on.
–Flashes in green while the cooling fan runs after the power is turned off with the I / 1 key. The fan runs for about 90 seconds after the power is turned off.
The ON/STANDBY indicator flashes quickly for the first 60 seconds. During this time, you cannot light up the ON/STANDBY indicator with the I / 1 key.
lLamp covermSecurity lockConnects to an optional security cable (Kensington’s).
Home page address: http://www.kensington.com/
nAdjuster adjustment buttonsFor details, see “How to use the adjuster” on page 10.
oAdjusterpSpeakerqVentilation holes (intake)/air filter cover•Do not place anything near the ventilation holes as it may cause internal heat
•Do not place your hand or objects near the ventilation holes as it may cause the air coming out heat
10 Location and Function of Controls
Note
To maintain optimal performance, clean
the air filter every 1500 hours.
For details, see “Cleaning the Air Filter” on page 44.
How to use the adjusterTo adjust the heightAdjusts the height of the projector as follows:
1 Lift the projector and press the adjuster adjustment buttons.
The adjusters will extend from the projector.
Adjuster adjustment buttons
2 While pressing the buttons, adjust the projector to the desired height, and then release the buttons. For fine adjustment, turn the adjusters to the right and the left.
to lower | to raise the |
the | projector |
projector |
|
Notes
•Be careful not to let the projector down on your fingers.
•Do not push hard on the top of the projector with the adjusters out.
It may be occurred malfunction.