Getting Started

Inserting Batteries Into the Remote Control (CDP- XE570/XE370 only)

You can control the player using the supplied remote.

Insert two R6 (size AA) batteries by matching the + and – on the batteries to the diagram inside the battery compartment.

Insert the negative (–) end first, then push in and down until the positive (+) end clicks into position.

When using the remote, point it at the remote

sensor

on the player.

Tip

When the remote no longer operates the system, replace both batteries with new ones.

Note

Do not leave the remote near an extremely hot or humid place.

Do not drop any foreign object into the remote casing, particularly when replacing the batteries.

Do not expose the remote sensor to direct sunlight or lighting apparatuses. Doing so may cause a malfunction.

If you don’t use the remote for an extended period of time, remove the batteries to avoid possible damage from battery leakage and corrosion.

Hooking Up the System

Hookups

This section describes how to hook up the CD

Getting

 

player to an amplifier. Be sure to turn off the

 

power of each component before making the

 

connections.

 

 

Started

 

 

CD player

 

 

 

ANALOG

ANALOG OUT

To mains

 

OUT

(White) (L)

 

(Red) (R)

 

 

 

Audio input

Audio input

 

 

(White) (L)

(Red) (R)

Amplifier

 

 

 

 

: Signal flow

To mains

Note

Install this system so that the power cord can be unplugged from the wall socket immediately in the event of trouble.

Tip (CDP-XE570/XE370 only)

You can adjust the analog output level to the amplifier using the remote comes with this player. Press ANALOG OUT LEVEL +/– on the remote. You can reduce the analog output level up to –20 dB. When you reduce the analog output level, “FADE” (or FADE for the CDP-XE370) appears in the display. When you turn off the player, the output level automatically returns to the maximum level.

continued

7GB