Sony XR350V, CX350V, CX370 manual Charging time, Getting started

You can charge the “InfoLITHIUM” battery pack (V series) after attaching it to your camcorder.

Notes

You cannot attach any “InfoLITHIUM” battery pack other than the V series to your camcorder.

1Turn off your camcorder by closing the LCD screen.

2 Attach the battery pack by aligning the battery terminals ( ) and pushing the battery pack in the direction of the arrow ( ) until it clicks.

3Connect the AC Adaptor and the power cord (mains lead) to your camcorder and the wall outlet (wall socket).

Align the mark on the DC plug with that on the DC IN jack.

The /CHG (flash/charge) lamp lights up and charging starts. The /CHG (flash/charge)

lamp turns off when the battery pack is fully charged.

4When the battery is charged, disconnect the AC Adaptor from the DC IN jack of your camcorder.

Tips

See page 96 on recording and playing time.

When your camcorder is on, you can check the approximate amount of remaining battery power with the remaining battery indicator at the upper left on the LCD screen.

Charging time

Approximate time (min.) required when you fully charge a fully discharged battery pack.

Battery pack Charging time

NP-FV50(supplied)155

NP-FV70195

NP-FV100390

Times measured with the camcorder at 25 C (77 °F). 10 C to 30 C (50 °F to 86 °F) is recommended.

Getting started

To remove the battery pack

Close the LCD screen. Pushing the PUSH (battery release) button ( ), remove the battery pack in the direction of the arrow ( ).

GB

13