Tip

If you made a mistake, press CANCEL. The setting entered last will be cleared. Re-enter it.

Tips

•To exit the standby mode, press STANDBY twice to make the t indication disappear.

•The preset settings remain until you reset them.

•When you select both sides recording, the recording will stop after the both sides recording finishes so that accidental recording will not be made.

•The display window does not light while the recording timer is on.

5 Set the timer to the hour and the minutes you want to start recording.

1Press TUNING

TIME SET + or – to set the hour and press

ENTER•MEMORY

CHECK.

2Press TUNING TIME SET + or – to set the minutes, and press ENTER•MEMORY CHECK.

6 Set the timer to the hour and the minutes you want to stop recording. (Do as step 5.)

7 Press TUNING TIME SET

+ or – to set the volume

you want, and press

ENTER•MEMORY CHECK.

8 Press STANDBY.

The power goes off and the player enters the standby mode. The tindication and the recording side of the tape (upper side (or reverse side

9) appear in the display. If the 9indication appears, press STANDBY to change the recording side to (.

At the preset time, the power will go on and the recording will start. Then the power will go off at the preset time, and the player will enter the standby mode again.

To check/change the recording timer settings

Press TIMER, then ENTER•MEMORY CHECK. Each time you press ENTER•MEMORY CHECK, a stored setting is displayed in the set order. To change the setting, display the setting you want to change and re-enter it.

To use the player before a timer-recording starts

If you turn on the player, you can use it as usual. Before the preset time, tune in the station you want to record and turn off the power.

To stop timer-recording

Turn off the power.

Timer The

TheTimer 33