PULLY AND DISC CENTER HOLE ALIGNMENT
cam | base unit |
cam
(1)Rotate the cam and adjust to the position shown in the figure.
(2)Check that the state is as shown in the figure.
bracket
(BU adjustment)
magnet ass’y
0.5 – 2 mm
disc
disc pulley
disc hole
base unit
Note: The disc should not be fixed.
holder (disc A2)
fixed screw
bracket
(BU adjustment)
tapering screwdriver
magnet ass’y
(3)Remove the Magnet ass’y.
(4)Loosen the fixed screw by 60° to 90°, and move and adjust the bracket (BU adjustment) up and down using a tapering screwdriver so that the positions of the disc hole and disc pulley become A=B or between A:B=2:1 and 1:2.
