OWNER’S MANUALENGLISH
LW5.830 | INPUTS & CONTROLS |
Subwoofer Switch (SUB on/off): | Low Pass Filter (LPF) CH 1/2 & 3/4: |
Activates CH 5 for subwoofer mode | Frequency adjustment 50 Hz to 650 Hz |
Bass Boost CH 5:
Adjust Bass Boost 0 – 18dB
Gain Control: Used to adjust gain to match source unit
High Pass Filter (HPF) CH 1/2 & 3/4: Frequency adjustment
50 Hz to 650 Hz
Low Pass Filter (LPF): |
Freq. adjustment |
50 to 250 Hz |
SUB CH4 CH2 GAIN
LPF CH1/CH2 HPF
Bass Boost CH 1/2 & 3/4: Switch 0 /+6 /+12dB
LOW
HI | INPUT | |
- | ||
|
-
+
+
. . . . | ON OFF |
|
| . | .0dB | 6dB12dB. | . LPF | HPF . . |
|
| |||
|
|
| MIN | MAX | 50Hz - 650Hz FULL 50Hz - 650Hz |
|
| ||||||
0dB 18dB | MIN | MAX |
|
|
|
|
|
| 6dB |
|
|
|
|
PWR/PRT . . . . |
|
|
| . . | 0dB | 12dB. . CH3/CH4 . . |
|
| |||||
|
|
|
| 50Hz - 650Hz | 50Hz - 650Hz | LOW | HIGH | ||||||
|
|
| MIN | MAX | BPF HPF | 50Hz- | 500Hz - | ||||||
50Hz - 250Hz | 0° | 180° |
| CH3 | CH1 | GAIN |
| LPF | LPF | 650Hz | 6.5KHz | ||
SUB | PHASE |
|
|
|
|
| FULLHPF |
|
| ||||
HIGH 500Hz - 6.5KHz
HI+
- + INPUT
-
Power LED: Green: power on
Red: protection mode
High Inputs CH 1/2:
High Level Input from source unit via speaker output
Phase Shift:
Adjust the acoustic Phase Shift from 0 – 180°
RCA Input CH 1/2 & CH 3/4: Input from source unit
via Cinch/RCA output
Low Pass Filter /
Full Range Mode /
High Pass Filter /
Band Pass Filter (only CH 3/4)
High Inputs CH 3/4:
High Level Input from source unit via speaker output
Frequency Range (HIGH/LOW) for
50 Hz to 650 Hz (LOW) or from
500 Hz to 6.5 kHz (HIGH) on CH 3/4
CAUTION: Please never use the RCA/Cinch Inputs and the High Level Inputs at the same time. Otherwise your amplifier will get damaged.
Fuses (located inside): Never replace with a fuse greater than specified
Subwoofer Output (CH 5): Use SUB only for a subwoofer operation
Speaker Output:
Left and right speaker connections. Use Left Positive (+) and Right Negative
Power Terminal:
Connect heavy (2 gauge / 35 sqmm) stranded wire to the 12 volt and grounded source. Connect the ground to the chassis near the amp
Connenct Remote Turn On wire from source unit with the REM input
SUB |
| BRIDGED |
|
| |
+ | + | - | + | - | +12V REM GND |
- | + | - | + | - |
|
SUB |
| BRIDGED |
|
| |
CAUTION: Please observe speaker channel and polarity as printed by the speaker terminal block. Incorrect phasing of the speakers results in total loss of bass response.
10
