OPERATING INSTRUCTIONS | OVEN / SMOKER |
RECEIPT AND INSTALLATION
RECEIPT:
IMMEDIATELY INSPECT FOR SHIPPING DAMAGE
All containers should be examined for damage before and during unloading. The freight carrier has assumed responsibility for its safe transit and delivery. If damaged equipment is received, either apparent or concealed, a claim must be made with the delivering carrier.
Apparent damage or loss must be noted on the freight bill at the time of delivery. The freight bill must then be signed by the carrier representative (Driver). If the bill is not signed, the carrier may refuse the claim. The carrier can supply the necessary forms.
A request for inspection must be made to the carrier within 15 days if there is concealed damage or loss that is not apparent until after the equipment is uncrated. The carrier should arrange an inspection. Be certain to hold all contents plus all packing material.
A.Inspect the entire perimeter of the package for damage or punctures to the packing material. This may indicate damage to the unit inside. Call any and all packing damage to the attention of the delivery person.
B.If any packing damage is found uncrate the unit immediately in the presence of the delivery person to determine if the unit is damaged. If any damage is found indicate the type and amount of damage on the shipping documents and notify Southbend at (919)
C.Uncrate the unit carefully and check the entire unit (top, front, back and both sides) for any visible or hidden damage.
D.Remove the unit from the shipping pallet and inspect the bottom for any damage.
E.If any damage is noted after the driver leaves immediately contact the freight company and Southbend.
F.Check each Oven Door. Make sure the Door closes completely, and that the Door Gasket seals firmly. If the Gasket does not seal correctly please contact the Southbend Service Department for instructions and assistance in any required adjustments.
INSTALLATION:
A.Check to determine that the power source is the same voltage and phase as that indicated on the label on the side of the unit.
B.If you have received an
C.Position the unit where it is to be operated and adjust the Appliance Legs of the
D.For the
For the
E.Carefully set all Controls and Switches to their OFF positions.
PAGE 6 OF 24 | INSTALLATION & OPERATIONS MANUAL 1189200 REV 0 (12/06) |