Hardware Setup | SY-5EHM/5EH5 |
3. Speaker
Attach the 4-pin PC speaker cable from the case to the Speaker connector on the mainboard.
4. Turbo LED
Connecting the 2-pin Turbo LED cable to the corresponding Turbo LED connector will cause the LED to light whenever the system is in Turbo mode.
The manufacturer has permanently set this mainboard in Turbo mode due to most hardware and software compliance to turbo mode.
5. IDE LED
Attach the 2-pin IDE device LED cable to the corresponding IDE LED connector on the mainboard. This will cause the LED to lighten when an IDE (HDD, CD-ROM) device is active.
6. ATX Power On/Off Switch
Attach the 2-pin momentary type switch to the PWRBT connector for turning On or Off your ATX power supply.
