SCSI Utilities
SY-D6IBA2 Quick Start Guide
68-pin Ultra-Wide SCSI Connector
68-pin
68-pin Ultra2 SCSI Connector
68-pin
Ultra2 SCSI allows you to connect up to 15 devices (LVD/SE mode) to the
Connecting Internal SCSI Devices
If you are connecting several internal SCSI devices (more than 2 SCSI devices), make sure you have an internal SCSI cable with enough connectors to accommodate all of your devices. The enclosed SCSI flat cables can serve up to 2 SCSI devices.
Follow these steps to ensure a proper installation of your internal SCSI devices:
1.Prepare each SCSI devices for installation; configure the device SCSI ID and terminators (terminate the last internal device attached to the cable by setting its termination to the ON position; all other internal devices on the SCSI bus must have their termination set to OFF).
2.Install the SCSI devices in your computer.
3.Plug the connector at one end of the internal SCSI cable into the host adapter’s SCSI connector on the Motherboard.
Note: Make sure the cable’s colored stripe is aligned with
4.Connect the remaining connectors on the cable to the SCSI devices
Note: Make sure the cable’s colored stripe is aligned with
5.Connect a DC power cable (from your computer’s power supply) to the power connector on each SCSI device.
18
