SOYO SY-D61BA2 quick start Power Button Enable JP7, JP7 Setting, Clear Cmos Data JP5

SY-D6IBA2Quick Start Guide

Step 6. Power Button Enable (JP7)

Your system can be power on by either pressing a power button or typing in a password, which can be set in the BIOS SOYO COMBO Setup. To avoid being unable to power up the system due to of forgetting the password, you can place a jumper cap to short JP7. This will always enable the Power Button.

Power Button	Power Button always	Power Button according to
Enable	enabled	BIOS setting
JP7 Setting	Short pin to always	Open pin for a Power
	enable the Power	Button function according
	Button.	to the BIOS setting.

Step 7. Clear CMOS Data (JP5)

Clear the CMOS memory by momentarily shorting pin 2-3 on jumper JP5 for at least 5 seconds, and then by shorting pin 1-2 to retain new settings. This jumper can be easily identified by its white colored cap.

CMOS Clearing	Retain CMOS Data		Clear CMOS Data
	Short pin 1-2 to retain		Short pin 2-3 for
JP5 Setting			at least 5 seconds
	the new settings.
			to clear the CMOS. 1 2 3
		2 3
	1

Note: You must unplug the ATX power cable from the ATX power connector when performing the CMOS Clear operation.

Hardware Installation

9