SOYO SY-K7VEMPRO V1.0 quick start Cmos Clear JP5

Hardware Installation

SY-K7VEMPRO V1.0 Quick Start Guide

ATX Power Supply: ATX PW

Attach the ATX Power cable to this connector. (This motherboard requires an ATX power supply, an AT power supply can NOT be used.)

Step 4. Configure Memory

Your board comes with two DIMM sockets, providing support for up to 1GB of main memory using unbuffered DIMM modules from 32MB to 512MB. PC100/133 DIMM module is required on this motherboard.

Memory Configuration Table

Number of Memory Modules	DIMM 1		DIMM 2
RAM Type		SDRAM
Memory Module Size (MB)
	32/64/128/256/512 MB

CMOS Clear (JP5)

In some cases the CMOS memory may contain wrong data, follow the steps below to clear CMOS memory.

1.Clear the CMOS memory by momentarily shorting pin 2-3 on jumper JP5. This jumper can be easily identified by its white colored cap.

2.Then put the jumper back to 1-2 to allow writing of new data into the CMOS memory.

CMOS Clearing	Clear CMOS Data			Retain CMOS Data
	Short pin 2-3 for			Short pin 1-2 to
JP5 Setting	at least 5 seconds to			retain new
	clear the CMOS			settings
	1	2	3	1	2	3

Note: You must unplug the ATX power cable from the ATX power connector when performing the CMOS Clear operation.

12