Speed Queen H3 Step 5: Remove the Shock Sleeves and Shipping Brace, 152.4mm (6 inches) in any direction, IMPORTANT: DO NOT tip washer more than, Reinstall front access panel

NOTE: DO NOT slide washer across floor if the leveling legs have been extended, as legs and base could become damaged.

NOTE: Use of the dispenser drawer or washer door as a handle in the transportation of the washer may cause damage to the dispenser or door.

Remove rubber feet from accessories bag and place on all four leveling legs.Verify that unit does not rock.

3

2

1

4

5

H381I

1Leveling Leg

2Washer Base

3Level

4Locknut

5Rubber Foot

Figure 10

Installation

Step 5: Remove the Shock Sleeves and Shipping Brace

Remove front access panel by removing the two screws.

Remove bolts and lockwashers from shipping brace with 9/16 in. wrench and remove brace. Remove shock sleeves by pulling on the yellow rope.

Remove label from front side of front access panel and place on backside of front access panel.

NOTE: The shipping brace, bolts, lockwashers and shock sleeves should be saved and MUST be reinstalled whenever the unit is moved more than four feet. Do not lift or transport unit from front or without shipping materials installed.

Store the shipping materials in the bag provided in the accessories bag. Save materials for use whenever the unit is moved.

NOTE: The shipping materials MUST be reinstalled whenever the unit is moved. Refer to Moving Unit to a New Location section for proper instructions on reinstalling the shipping materials.

Reinstall front access panel.

IMPORTANT: DO NOT tip washer more than

152.4mm (6 inches) in any direction after shipping brace has been removed. Shock absorbers may separate and damage machine. For leveling purposes, the washer may be tilted a maximum of

152.4mm (6 inches) in any direction.

801561 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 11