Installation

Water Temperature

Cold:

Recommended cold water temperature is 16° to 27° Celsius (60° to 80° Fahrenheit).

Hot:

Recommended hot water temperature is 49° to 60° Celsius (120° to 140° Fahrenheit).

Warm:

Mixture of hot and cold water (warm water temperature is dependent upon the water temperature and the pressure of both the hot and cold water supply lines).

IMPORTANT: Turn off water supply faucets after check-out and demonstration. Owner should turn off water supply whenever there will be an extended period of non-use.

NOTE: Longer inlet hoses are available (as optional equipment at extra cost) if the hoses (supplied with the washer) are not long enough for the installation. Order hoses as follows:

No. 20617 Inlet Hose (2.44 m) (8 ft.)No. 20618 Inlet Hose (3.05 m) (10 ft.)

12

WATER

MIXING

VALVE

4

3

 

 

FLW2008N

FLW2008N

1Water Supply Faucets

2Cold Water Connection

3Hot Water Connection

4Water Inlet Hoses

Figure 18

Water Pressure

Pressure must be a minimum of 138 to a maximum of 827 kPa (20 to 120 pounds per square inch) static pressure measured at the faucet.

NOTE: Water pressure under 138 kPa (20 pounds per square inch) will cause an extended fill time in the washer and may not properly flush out the detergent dispenser.

Risers

Risers (or air cushions) may have to be installed if the pipes knock or pound when flow of water stops. The risers are more efficient when installed as close as possible to the water supply faucets (refer to Figure 19).

2

1

W005I

1Water Supply Faucets

2Risers (Air Cushions)

Figure 19

16

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

801561