Speed Queen TMB1268C Electronic OPL Control, H, L, P, S, U, X and Y Models with RM Control Suffix, RESET, Figure, Programming Manual, 3. Press START pad to start tumbler

Electronic OPL Control

H, L, P, S, U, X and Y Models with RM Control Suffix

1.To use an Automatic Cycle, press an ON/ SELECT pad. Select HIGH, MEDIUM, MED LOW, LOW or NO HEAT for items that should not be dried with heat. A light to the left of the selected pad lights up.

To use a Time Dry or Custom Cycle, refer to the Programming Manual.

ON / SELECT

HIGH

MEDIUM

MED LOW

LOW

NO HEAT

TMB1483N

Figure 15

NOTE: Do not press directly on lights or the center of pad. For proper selection, press on pad slightly to the right of center. Refer to Figure 16.

TMB806N

Figure 16

Installation/Operation Supplement

2.Select REVERSING or NON-REVERSING cylinder rotation setting.

REVERSING

TMB1486N

Figure 17

3. Press START pad to start tumbler.

START

TMB1485N

Figure 18

NOTE: All pads can be pressed in any sequence without damaging control or tumbler. To stop the tumbler at any time, open the door or press STOP/

RESET.

STOP/RESET

TMB1484N

Figure 19

NOTE: The window display will flash. Press STOP/ RESET twice (within three seconds) to end the cycle and reset the control to idle status. To restart the tumbler, CLOSE door and press START pad.

IMPORTANT: If the loading door or lint panel door is opened during the cycle, the heating system will shut off and the motor will stop. To restart the cycle, both doors must be closed and the START pad must be pressed.

4.When the cycle is complete, open door and remove the laundry.

M414881 (EN)