Electronic OPL Micro Control
G Models Through Serial No. 0110002231 and H, L, P, S, U and Y Models with
OM and RM Control Suffixes
1.To use an Automatic Cycle, press an ON/ SELECT pad. Select HIGH, MEDIUM, MED LOW, LOW or NO HEAT for items that should not be dried with heat. A light to the left of the selected pad lights up.
To use a Time Dry or Custom Cycle, refer to the
Programming Manual.
ON / SELECT
HIGH
MEDIUM
MED LOW
LOW
NO HEAT
TMB1483N
Figure 18
NOTE: Do not press directly on lights or the center of pad. For proper selection, press on pad slightly to the right of center. Refer to Figure 19.
TMB806N
Figure 19
2.Select REVERSING or NONREVERSING cylinder rotation setting.
REVERSING
TMB1486N
Figure 20
Installation/Operation Supplement
3. Press START pad to start tumbler.
START
TMB1485N
Figure 21
NOTE: All pads can be pressed in any sequence without damaging control or tumbler. To stop the tumbler at any time, open the door or press STOP/
RESET.
STOP/RESET
TMB1484N
Figure 22
NOTE: The window display will flash. Press STOP/ RESET twice (within three seconds) to end the cycle and reset the control to idle status. To restart the tumbler, CLOSE door and press START pad.
IMPORTANT: If the loading door or lint panel door is opened during the cycle, the heating system will shut off and the motor will stop. To restart the cycle, both doors must be closed and START pad must be pressed.
4.When the cycle is complete, open door and remove the laundry.
M414884 (EN) | © Published by permission of the copyright owner – DO NOT COPY or TRANSMIT | 25 |