Installation/Operation Supplement
G Models Starting Serial No. 0707xxxxx and K Models with OM and RM Control Suffixes
1.To use an Automatic Cycle, press a TEMPERATURE pad. Select HIGH, MED, LOW, DELICATE or NO HEAT for items that should not be dried with heat. A light to the left of the selected pad lights up.
To use a Time Dry or Custom Cycle, refer to the
Programming Manual.
TMB2201N
Figure 23
2.Select REVERSING or NONREVERSING cylinder rotation setting.
TMB2206N
Figure 24
3. Press START pad to start tumbler.
TMB2202N
Figure 25
NOTE: All pads can be pressed in any sequence without damaging control or tumbler. To stop the tumbler at any time, open the door or press STOP.
TMB2203N
Figure 26
NOTE: The window display will flash. Press STOP twice (within 3 seconds) to end the cycle and reset the control to idle status. To restart the tumbler, CLOSE door and press START pad.
IMPORTANT: If the loading door or lint panel door is opened during the cycle, the heating system will shut off and the motor will stop. To restart the cycle, both doors must be closed and the PUSH TO START button must be pressed in.
4.When the cycle is complete, open door and remove the laundry.
26 | © Published by permission of the copyright owner – DO NOT COPY or TRANSMIT | M414884 (EN) |