Installation

Step 5: Position and Level the Washer

Position washer so it has sufficient clearance for installation and servicing.

Place rubber feet on all four leveling legs.

Place washer in position on a clean, dry, and firm floor. Do not install the washer on carpeting.

Loosen 7/8 inch locknuts and adjust the two front leveling legs. Once adjusted, tilt the unit forward on front legs and lower back down into position to set the rear self-leveling legs.

Washer must not rock. After washer is at desired height, tighten locknuts securely against bottom of washer base. If these locknuts are not tight, washer will not remain stationary during operation.

Improper installation or flexing of a weak floor will cause excessive vibration.

Do not slide washer across floor once the leveling legs have been extended, as legs and base could become damaged.

Verify that washer does not rock.

1

5

 

2

4

3

 

W179I

1Level

2Locknut

3Leveling Leg

4Rubber Foot

5Washer Base

Figure 12

Step 6: Connect the Washer to Electrical Power

Refer to section on Electrical Requirements and connect the washer to an electrical power source.

D254I

WASHER MANUFACTURED WITH PLUG

D254I

Figure 13

WASHER MANUFACTUREDTLW1937NWITHOUTW458IE1APLUG

TLW1937N

W458I

Figure 14

14

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

39971