Maintenance
User-Maintenance Instructions
Cold Weather Care
If the washer is delivered on a cold day (below freezing), or is stored in an unheated room or area during the cold months, do not attempt to operate it until the washer has had a chance to warm up.
Care of Your Washer
Use only a damp or sudsy cloth for cleaning the control panel.
Wipe the washer cabinet as needed. If detergent, bleach or other washing products are spilled on the cabinet, wipe immediately.
Do not use scouring pads or abrasive cleansers on any part of the washer.
The washtub will need no particular care though it may need rinsing or wiping after an unusual load has been washed.
Leave the lid open to allow the inside of the washer to dry out after use. This helps prevent musty odors from developing.
Replacing Hoses
Hoses and other natural rubber parts deteriorate after extended use. Hoses may develop cracks, blisters or material wear from the temperature and constant high pressure they are subjected to.
All hoses should be checked on a yearly basis for any visible signs of deterioration. Any hose showing the signs of deterioration listed above should be replaced immediately. All hoses should be replaced every five years.
Vacations and Extended Non-Use
IMPORTANT: To avoid possible property damage due to flooding, turn off the water supply to the washer whenever there will be an extended period of
Filter Screens
Check the filter screens in the fill hoses for debris or damage annually. Clean or replace them if necessary.
If the washer is filling with water slower than normal, check the filter screens. Clean or replace them if necessary.
Order filter screen Part No. F270300 from the nearest authorized parts distributor.
Reinstallation of Shipping Materials
Shipping Brace
The shipping brace in the lid opening should be saved and reinstalled whenever the washer is moved. To reinstall the brace, open the washer lid and place the brace over the washer agitator, placing the back of the brace into the washtub first.
Shipping Plug
The plastic shipping plug should be saved and reinstalled any time the washer is moved. The plug fits into two openings: The base opening and the shipping plug opening on the bottom of the mobile pivot dome. The plug MUST be inserted into both openings to prevent damage to the washer. Refer to Figure 29.
1
2
3
TLW544N
1Shipping Plug Opening
2Base Opening
3Shipping Plug
Figure 29
Motor Overload Protector
This internal overload protector will stop the motor automatically in the event of an overload. The overload protector will reset itself in two or three minutes and the motor will restart automatically. If the overload protector stops the motor again, remove the washer from use and call the service person to correct the problem.
39971 | © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT | 25 |