Sprint Nextel 2012J To program the Time and Date, Adjusting the LCD Contrast Level, Basics

10:53 - 6/18

TOTAL 00 NEW 00

(Example: 10:53 a.m. on June 18th)

correct num-

To program the Time and Date:

Press the UP and DOWN buttons to get to the ber and the DELETE button to accept.

10:00 - 0/0

SET HOUR

10:53 - 0/18

SET DATE

10:53 - 0/0

SET MINUTES

10:53 - 6/18

SET MONTH

NOTE: You may not have to set up the Time and Date manually as it may be auto- matically updated by Call Display infor- mation when your phone rings (twice or more). To get back to the standby mode (for dialing), press the DELETE button

until the normal display shows (see right for example).

Adjusting the LCD Contrast Level

You can also adjust the grey-level of the display without enter- ing the initial setup mode. Hold the DELETE button, then press the CALL BACK button to enter the LCD CONTRAST level setting mode. Use the UP or DOWN button to select the suitable grey-level and press the DELETE button to accept.

BASICS

Choosing Tone or Pulse Dialing

Select the type of dialing by setting the TONE/PULSE switch. If you are not sure of your dialing system, make a trial call with the switch set to TONE. If the call connects, leave the switch as it is; otherwise, set it to PULSE. Even when your phone is set to pulse service, this phone can be switched to temporary tone for access to services that require tone sig- naling including Telephone Banking. Just press the TONE button after dialing in pulse and your buttons can now be used for tone signaling for this call only.

5