Preparation
1 Lift the handset, then press PHONE and listen for the dial tone.
Illustration of handset
2 Press any number other than 0.
Note: If your phone system requires that you dial an access code (9, for example) before you dial an out- side number, do not press the access code either.
If the dial tone stops, you have
If the dial tone continues, you have pulse service. Press PHONE PROG/MEM # # # 3.
If your phone is set for pulse service and you want to change the dialing mode to
SETTING THE DAY AND TIME
You can use the handset as well as the keys on the base to operate the TAD. To use the handset, simply press ANS SYS to access the TAD before beginning each procedure. The ANS SYS indicator lights and the TAD an- nounces the number of messages then beeps twice.
Follow these steps to set the day and time so the TAD can record the correct information when each message and memo is received.
Note: If you do not complete each step within 20 seconds, the TAD sounds two beeps and exits setup. Start again at Step 1.
1Press CHANGE then CLOCK. A number from
illustration of
base front
Note: The TAD’s message counter window might also alternately show other information to tell you the status of the TAD.
2Press REPEAT/SCAN or SKIP/SCAN as instructed by the voice prompts.
illustration of base front
3When you complete setting the day and time, the TAD announces the day and time then beeps twice.
To check the current day/time at any time, press CLOCK.
ANNOUNCEMENT OPTIONS
Before using the
If you do not record a personalized outgoing message, the TAD plays Hello. Please leave a message after the tone.
8