Installation
MOUNTING THE BASE ON A WALL
Note: To mount the base directly on the wall, you need two screws (not supplied) with heads that fit into the keyhole slots on the bottom of the base. Drill two holes 315/16 inches (100 mm) apart, one above the other. Then thread a screw into each hole, letting the heads extend about 5/16 inch (7 mm) from the wall.
1Remove the bracket by pressing on the arrows and gently pulling out the wide end of the bracket.
2Plug one end of the supplied modular cord into the LINE jack. Route the modular cord through the curved channel on the bottom of the base. Then wrap any excess modular cord around the two
3Insert the tabs on the narrow end of the bracket into the upper slots on the bottom of the base. Insert the loose end of the modular cord through the center of the bracket. Route the end of the adapter cord through the opening on the wide end of the bracket. Then push the tabs on the wide end of the bracket into the lower slots on the bottom of the base.
Illustration
LINE Jack | POWER Jack |
Upper Slots
Adapter
Cord
4Plug the modular cord’s other end into the wall plate jack (or a modu- lar phone line jack), align the base’s keyhole slots with the wall plate studs
(or the screws in the wall), and slide the base downward to secure it.
Lower Slots
Illustration
5Plug the adapter into a standard AC outlet. Fully extend the base’s antenna and raise it to a vertical position.
Illustration - adapter to outlet and antenna to vertical
INSTALLING AND CHARGING THE BATTERY PACK
The
1Press down and slide off the compartment cover. Plug the battery pack connector into the phones socket. The connector fits only one way. Replace the cover.
To charge the battery pack, simply place the handset on the base. The CHARGING indicator on the base lights.
illustration of base front with handset on base
6