ASSEMBLY INSTRUCTIONS
Place all parts from the box in a cleared area and position them on the floor in front of you. Remove all packing materials from your area and place them back into the box. Do not dispose of the packing materials until assembly is completed. Read each step carefully before beginning. If you are missing a part please call our
Nylock Nut(M8) |
Plastic Washer |
Fixing Tube |
R |
NOTE: Remove the FIXING TUBES, WASHERS, and NUTS from MAIN FRAME(1) and REAR FRAME(2) before any assembly. These parts are only for packing, do not dispose of the packing materials until assembly is completed.
STEP 1
The FRONT STABILIZER(4) has two MOVING WHEELS(48) with an "R" decal on one end. Attach the FRONT STABILIZER(4) to the MAIN FRAME(1) with the wheels facing front and the "R" decal at the right side as shown in the illustration. Secure with the CARRIAGE BOLTS(M8x1.25x60mm)(56), ARC WASHERS(M8)(74), and ACORN NUTS(M8x1.25)(69).
STEP 2
Attach the REAR STABILIZER(3) to the REAR FRAME(2) with CARRIAGE BOLTS(M8x1.25x60mm)(56), ARC WASHERS(M8)(74), and ACORN NUTS(M8x1.25)(69).
NOTE: You can adjust the LEVELING CAPS(50) on the REAR STABILIZER(3) to keep the INTONE Folding Recumbent Bike stable.
STEP 3
Store the PULL PIN(47) by inserting the pin into the hole in the REAR FRAME(2).
6
