OPERATIONAL INSTRUCTIONS
WOODEN BARRE ADJUSTMENT
To adjust the height of the WOODEN BARRE(13). Turn
the SPRING PINS(12) on the LEFT and RIGHT SLIDERS
(8, 10) counter clockwise until the knob portion can be
pulled. Pull both SPRING PINS(12) at the same time and
slide the SLIDERS(8, 10) up or down to adjust. Release
the SPRING PINS(12) to lock the SLIDERS(8, 10) in the
desired adjustment holes. Rotate the SPRING PINS(12)
clockwise to lock the SLIDERS(8, 10) securely.

NOTE:

Always make sure that the SLIDERS(8,10) are adjusted
so the barre is parallel with the mat.
10
MAINTENANCE
The safety and integrity designed into the Studio Tower can only be maintained when the Studio Tower
is regularly examined for damage and wear. Special attention should be given to the following:
It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.
Worn or damaged components should be replaced immediately or the Studio Tower removed from
service until repair is made.
Verify that the WARNING LABEL(63) is present and legible. Repla ce the W A RNING LABEL(63) if it is
missing or damaged.
Inspect the WOODEN BARRE(13) for cracks or other damage. Replace the WOODEN BARRE(13) if it
is damaged.
Check the condition of the SAFETY STRAP(37). Replace the strap if da maged or worn.
Check the condition of the SPRINGS(34, 35, 36). Replace the springs that are damaged.
Check the HAND STRAPS(21) for damage. Replace damaged parts.
Check the FOAM SLEEVE(29), and SPRING SLEEVE(33) and replace if damaged or worn.
Check the CUSHIONS(2, 4, 6) and replace if it is damaged or worn.
Only Stamina Products supplied components shall be used to maintain/repair the Studio Tower .
Keep your Studio Tower clean by wiping with an absorbent cloth after use.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.