ASSEMBLY INSTRUCTIONS
Place all parts from the box in a cleared area and position them on the floor in front of you. Remove all packing materials from your area and place them back into the box. Do not dispose of the packing materials until assembly is completed. Read each step carefully before beginning. If you are missing a part please call our
STEP 1
Remove your AeroPilates® Performer 286 from its packaging, placing the product on its side with the LOCKING PIN(26) side upward. Remove the LOCKING PIN(26) and unfold the MAIN FRAME ASSEMBLY separating the half that has the attached LOCKING PIN(26). When completed, the frame should form a "V" with the frame ends separated approximately three feet.
STEP 2
Attach the four RUBBER FEET(25) to the FRONT FRAME(1) and REAR FRAME(2) with ROUND HEAD SCREWS(M5x0.8x35mm)(37). The ROUND HEAD SCREWS(M5X0.8X35mm)(37) are already in the RUBBER FEET(25). Attach the PLASTIC WHEELS(24) onto the FRONT FRAME(1) with WASHERS(M8)(46) and NYLOCK NUTS(M8)(40).
STEP 3
Unfold your AeroPilates® Performer 286 to a flat position by moving the FRONT FRAME(1) away from the platform end of the REAR FRAME(2) in a clockwise position until fully extended.
7
