ASSEMBLY INSTRUCTIONS
BACK VIEW |
STEP 9
Refer to the inset drawing. Attach the SLIDER SUPPORT(14) to the LOWER UPRIGHT(6) with HEX BOLT (M12x1.75x160mm)(77), WASHERS(M12)(80), and NYLOCK NUT(M12x1.75)(82). Do not over tighten the bolt, as the SLIDER SUPPORT(14) must be able to pivot smoothly.
STEP 10
Pull the SPRING PIN(34) on the SLIDER SUPPORT(14). Then insert the ADJUSTMENT BAR(13) into the SLIDER SUPPORT(14) and lock in the top adjustment hole with the SPRING PIN(34).
STEP 11
NOTE: Do not over tighten the BOLTS(74, 77), as the BACK SUPPORT(12) must be able to pivot smoothly.
Attach the BACK SUPPORT(12) to the LOWER UPRIGHT(6) with HEX BOLT(M12x1.75x90mm)(74), WASHERS(M12)(80), and NYLOCK NUT(M12x1.75)(82). Attach the BACK SUPPORT(12) to the ADJUSTMENT BAR(13) with HEX BOLT(M12x1.75x160mm)(77), WASHERS(M12)(80), and NYLOCK
NUT(M12x1.75)(82).
9
