3.1SET UP
After the Radar Antenna is installed, select FULL PAGE and perform the following steps in the order shown below.
3.1.0Transmission Trigger Delay
Tuning the Transmission Trigger Delay sets up the Radar to accurately show distance of targets.
1.From the Full Page Radar display, press [MENU]. Move the ShuttlePoint knob to highlight RANGE and press [ENT].
Figure 3.1.0 - Range Menu
2.Move the ShuttlePoint knob to highlight ¼ NM range and press [ENT].
3.Move the ShuttlePoint knob to highlight SENSITIVITY and press [ENT].
Figure 3.1.0a - Sensitivity Menu
4.Move the ShuttlePoint knob to highlight SEA CLUTTER and press [ENT].
5.Move the ShuttlePoint knob until 000 is shown, then press [ENT].
6.Move the ShuttlePoint knob to highlight RAIN CLUTTER and press [ENT].
7.Move the ShuttlePoint knob to the right to highlight OFF, then press [ENT].
8.Press [CLR].
9.Move the ShuttlePoint knob up to highlight TUNING and press [ENT].
10.Move the ShuttlePoint knob to highlight TX TRIGGER DELAY and press [ENT].
Figure 3.1.0b - Tuning Menu
11. Move the ShuttlePoint knob right or left to adjust the GAIN to show targets (example 017).
Page 14 |
| Radar Operation Manual |
|