Standard Horizon CP500, CPV550, CP180I, CP300 operation manual Introduction, Conventions Used

1. INTRODUCTION

1.0CONVENTIONS USED

Please refer to the legend below:

[MENU]	If you see brackets around a bold and capital letter word this refers to a key press.
[CHART]	If you see brackets around a bold and small capital letter word this refers to a Soft Key
	press.

GENERAL SETUP When a word(s) is in bold capital letters and underlined, this refers to a menu selection item.

1.1INTRODUCTION

Any menu operation and functions activation in this Operation Manual is related to the following Chart Plotter models with software capable to operate a Radar Antenna. Whenever it is necessary, a note has been inserted for those models with operational differences.

·CP180

·CP180i

·CP300

·CP300i

·CPV350

·CP500

·CPV550

To confirm the Chart Plotter has the software to operate a Radar Antenna:

1.Turn on the Chart Plotter, select the chart page.

2.Press [MENU] and look for a Radar selection.

If the Chart Plotter has a Radar selection, it has the software. If the Chart Plotter does not have the software, it is available by contacting Standard Horizon Marine Product Support at 800/767-2450 (USA) or Standard Horizon/Vertex Standard authorized dealers (outside the US and Canada) for a Software Card. Refer Si-Tex Installation Manual for software update procedure.

1.2GENERAL INFORMATION

PRODUCT SUPPORT INQUIRIES

If you have any questions or comments, we invite you to visit www.standardhorizon.com to send an E-Mail or contact the Product Support team at 800-767-2450 M-F 7:00-5:00PST (in USA or Canada) or Standard Horizon/Vertex Standard authorized dealers (Outside USA or Canada).

Radar Operation Manual Page 7