Page 26 Radar Operation Manual
Status Bar displayed always in compact mode to allow more space for the graphical data.
To enable (On) or disable (Off) the Status Bar display, follow this procedure:
1. Press [MENU]. Move the ShuttlePoint knob to highlight STATUS BAR and press [ENT].
2. Move the ShuttlePoint knob to highlight ON or OFF and press [ENT].
15
3
2
4
7
6
RANGEand Range rings interval
GuardZone alarms
CurrentHeading
HeadingMode indication
MotionMode indication
ShipSpeed Over Ground
CourseOver Ground
5
3
2
7
4
1
6
Figure 4.1.9 - Status Bar
4.2 SENSITIVITY
To select the Sensitivity menu follow this procedure:
1. Press [MENU]. Move the ShuttlePoint knob to highlight SENSITIVITY and press [ENT].
NOTE
The Sensitivity menu can be also opened by pressing [ENT] directly from the Radar page when the
Cursor is not placed over any features.
4.2.0 Interference Rejection
Reduces the interference caused by signals from other Radar units. It is possible to turn
Interference Rejection to Off, Level 1 (weak), Level 2 (middle), Level 3 (strong). The higher
you set the Interference Rejection value the less interference you will receive.
To select the Interference Rejection value, follow this procedure:
1. Press [MENU]. Move the ShuttlePoint knob to highlight SENSITIVITY and press [ENT].
2. Move the ShuttlePoint knob to highlight INTERFERENCE REJECTION and press [ENT].
3. Move the ShuttlePoint knob to highlight the desired Interference value and press [ENT].
4.2.1 Gain Adjustment
Controls the Radar Gain. To see more details on the screen, increase the receiver sensitivity
by selecting a higher gain percentage. If there is too much detail or if the screen is cluttered,
lowering the sensitivity may increase the clarity of the display.
To select the Gain value, follow this procedure:
1. Press [MENU]. Move the ShuttlePoint knob to highlight SENSITIVITY and press [ENT].
2. Move the ShuttlePoint knob to highlight GAIN ADJUSTMENT and press [ENT].
3. Move the ShuttlePoint knob up/down to insert the desired value and left/right to move the
cursor. When finished, press [ENT].