Figure 3.1.4 - Heading Line (I)
d. Press [CLR] until the Radar page is shown.
2.Select a target about 1- 2NM and adjust the vessels speed to accurately head to the to the target (preferably on a flat calm day).
3.If the target is not shown directly ahead on the Radar full page display, adjust heading the line to correct the target heading.
4.Press [MENU]. Move the ShuttlePoint knob to highlight TUNING and press [ENT].
5.Move the ShuttlePoint knob to highlight HEADING LINE and press [ENT].
6.Apply the heading correction.
Figure 3.1.4a - Heading Line (II)
7.Press [ENT]. The screen updates as the heading line is adjusted.
8.Press [CLR] to exit from menu.
9.Repeat the steps
3.1.5Antenna Parking Position
(ONLY FOR MDS-9 DOME & MDS-10-4/MDS-10-5 OPEN ARRAY ANTENNAS)
When the Radar is turned Off, the Antenna comes to a stop. If you want to have the Antenna to stop in a specific position, the Antenna Parking Position function can be used to choose the desired Antenna position. This function only controls the Antenna position at which the power to the motor is cut off. The distance through which it comes to a stop from this point depends on temperature and wind conditions. The setting of Antenna Parking Position does not affect the operation of the Radar at all.
The Antenna Parking Position can be set as follows:
1. Press [MENU]. Move the ShuttlePoint knob to highlight TUNING and press [ENT].
Page 18 |
| Radar Operation Manual |
|