EP30250 MAINTENANCE
PIN HOLDERS
Squeeze the fingers on the pin holder together each time you feel that the brazing pin goes in too easy when mounting them into the pin holder. This is important since all the current goes thru the pin holder to the brazing pin. If the fingers are too loose the pin holder will be damaged and must be replaced.
CHANGE PIN HOLDER
-Separate the ring holder from the gun with your hands. -Hold the nut closest to the pin holder with a 10mm key.
-Screw the pin holder off.
-When replacing the new pinholder, hold the nut, closest to the pinholder even now.
WARNING
WARNING! Never rotate the shaft! The internal cables may be damaged!
EQUIPMENT
-Check the cables from time to time, to make sure they are not damaged.
-Check the contact surface on the ground magnet from time to time and use a file to even or clean the surface.
BRAZING PINS AND FERRULES -Keep them dry.
RAILBONDS AND CABLE LUGS -Keep them free from oxidation.
-Keep them free from contamination like: Grease, oil, dirt, paint, glue etc. -Make sure that they are not damaged.
EP30200 / EP30250 User Manual ◄ 13
