EP30200 OPERATION
a. The ring holder is a "push fit" to the gun. To remove it from the gun, simply pull it away from the gun.
b. The pin holder is threaded onto a threaded shaft in the gun and locked in place with a nut. Place an open end wrench over the nut and an open end wrench over the flats on the pin holder. While holding the nut in place, unscrew the pin holder counter clockwise.
Pin Holder
Figure 3. Pin and Ring Holder
c. Install the correct pin holder and tighten it securely against the nut.
IMPORTANT
Make sure, never twist the axle when mounting the pin holder.
d. Install the correct ring holder by placing it over the pin holder and into the circular groove in the gun, and finally, pushing on it to seat it in place.
LOADING PIN AND RING
6.Insert the brazing pin into the pin holder. The rounded tip should be facing away from the gun.
7.Insert the ceramic ring into the ring holder. The serrated edge should be facing away from the gun. See figure 4.
Figure 4. Loading pin and ring
ADJUSTING BRAZING PIN DISTANCE TO BRAZE SURFACE
8 ► EP30200 / EP30250 User Manual
The BG10100 automatically adjusts the correct distance of the brazing pin to the surface to be brazed.
NOTE:
The BG10100 may be adjusted manually if necessary using the dial located on the back of the gun. The set- tings are as follows:
+ = 2.5 mm distance
0 = 2.0 mm distance (normal position)
Dial
Figure 2. Gun Adjustment Dial
8.Plug the two gun cable into the appropriate outlets on the control box.
SET CONTROL FOR PIN SIZE
9.Set the PIN TYPE switch on the control box for the appropriate pin type being used. See Figure 3 below.
Brazing Pin | Setting |
8 mm Std | P1 |
8 mm Extra | P2 |
9.5 mm | P3 |
SWITCH
