Safety Notices
This printer is certified as a Class I laser product under the lJ.S.Department of Health and Human Services
(DHHS) Radiation Performance Standard according to the Radiation Control for Health and Safety Act
of 1968. This means that the prmter does not produce hazardous laser radiation.
Since radiatton emitted Inside the printer is completely confined within protective housings and external
covers. the laser beam cannot escape from the machine during any phase of user operation.
The Center for Devices and Radiological Health (CDRH) of the U.S.Food and Drug Administration
implemented regulations for laser products on August 2. 1976. These regulations apply to laser products
marketed in the United States. The label on the printer indicates compliance with the CDRH regulations
and must be attached to laser products marketed in the United States.
Caution-use of controls or adjustments or performance of procedures other than those specified herein
may result in hazardous radiation exposure.
Federal Communications Commission
Radio Frequency Interference Statement
Thts equipment has been tested and found to comply with the limits for a Class B digital devtce, pursuant
to Part IS of FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. Thts equipment generates. uses and can radiate radio frequency
energy and. if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, whtch can
be determined by turning the equipment off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
- Reorient or relocate the receivmg antenna.
* Increase the separation between the equipment and receiver
l Connect the equipment into an outlet on a circuit different from that to wahich the receiver is
connected.
l Consult the dealer or an experienced radio/TV technician for help.
For comphance with the Federal Noise Interference Standard, this equipment requires a shielded cable.
The ohorv .~t~~en~ents up/‘/y only to prinrers murkrtrd in thr U.S.A.
Self Declaration
Radio interference regarding this equipment has been eliminated according to Vfg lOS6/1984 announced
by the DBP.
DBP has been informed of the introduction of this special equipment and has been granted the right to
examine the whole series.
It IS the user’s responsibility to see that his own assembled system is in accordance with the technical
regulations under Vfg 1046/1984.
To conform to FIXregulations it is necessary to make all connections to the printer wtth shielded cable.
The equipment may only be opened by qualified service representatives.
The uhm~ srurement applirs on!, to pinte~~ murketed ,n Gemuny.
--
-
-,
-
-
-
-
-
-
- v - -