5) Select “Graphics Printer(s)” and press [RETURN], which displays the
Graphics Printer(s) screen.
6) Select “HP” and press [RETURN] to display the Graphics Printer(s)
screen.
7) For 150 or 300DP1, select “LaserJet+” and press [RETURN]. For 75DP1,
select “LaserJet” and press [RETURN].
When you have completed the selection of a graphics printer, press [FlO].
Your current selections will displayed. Make sure that the selections are
correct. If not, repeat the installation process.
To save your selections, press [Esc] to return to the Selected Equipment
screen.
1) Select “Save Changes” and press [RETURN], which displays the Saving
Changes screen.
2) Read message and press [RETURN].
3) Now, you have saved the changes you made. Press[F9] to go to the Main
Menu, or press [RETURN] to leave the install program. The EXIT screen
will be displayed.
4) Select “YES” and press [RETURN].
l Selecting Default Settings
After running the INSTALL program, you must select printer defaults.
At the DOS prompt, type LOTUS and press [RETURN] to display the 1-2-
3 Access System, Move the cursor to “ 1-2-3”, then press [RETURN] to run
the l-2-3 program. Lotus may ask you to insert the SYSTEM disk.
At the opening screen, press [/] to access the spreadsheet menu. Then, type
[Wlorksheet, [Gllobal, [DIefault and [Plrinter. The configuration menu will
be displayed. Now you are ready to make some selections about the
configuration of your Star LaserPrinter 4111.
1) Type [I] Interface and select the number which corresponds Ihe interface
for your printer.
For parallel, type “l”, and for serial, type “2” (for example).
2) Select appropriate settings for auto linefeed, left margin, right margin, top
margin, bottom margin, page length, wait, setup and name.
63