Star Micronics DP8340R user manual D-Sub 25 Pin Connector

Figure 8-5. D-Sub 25 Pin Connector

*1 Error Condition Alarm Mode

If an error condition is detected during operation, the printer will stop printing and cause the FAULT signal to go MARK. All solenoides & motors will be de-energized. It is necessary to turn the printer power off and on again in order to recover from the alarm mode.

This printer can detect the following error coditions:

a.Motor Lock

b.Defective timing detector

c.Micro-proccessor out of program sequence

8-6. Interface Connections

For interface connections, refer to the instructions for interface of the host computer. The following gives one basic example of connections.

Figure 8-6. Interface Connections

with D-Sub 25 Pin Connector to IBM PC

D

TYPE

ONLY

– 35 –