Star Micronics DP8340R user manual Setting of the DIP Switches

8-3. Setting of the DIP Switches

8-3-1.	DIP-SW 1
Switch		ON	OFF	Factory
				setting
1-1				ON
1-2		Data transfer rate — see below (*1)		ON
1-3				ON
1-4		Stop bit 1	Stop bit 2	ON
1-5		DTR MODE (1 BLOCK)	X-ON/X-OFF MODE	ON
1-6		8 data bits	7 data bits	ON
1-7		No parity	Parity checked	ON
1-8		Odd parity	Even parity	ON

(*1)

Baud rate	SW1-1	SW1-2	SW1-3
150	OFF	OFF	OFF
300	OFF	OFF	ON
600	OFF	ON	OFF
1200	OFF	ON	ON
2400	ON	OFF	OFF
4800	ON	OFF	ON
9600	ON	ON	ON/OFF

(*2) DIP Switch 2-3 should be set to ON when you use a 2-color ribbon for 2-color printing.

It should be set to OFF when a monochrome ribbon is used.

8-3-2.	DIP-SW 2
Switch		ON		OFF	Factory
					setting
2-1		International character set :			ON
		U.S.A		FRANCE
2-2			Always ON		ON
2-3(*2)		2-color Ribbon		Monochrome Ribbon	ON
2-4		CR Invalid		CR Valid	ON

Note: DIP switches are only read by the controller at power turn on. DIP switch changes should be made with power off, or after changing switch setting, turn the power off and on again.

Figure 8-3. Setting of DIP Switch

– 32 –