Star Micronics SP2000 Series user manual Level

ENGLISH	Level 3	…
	Level 2	……
	Level 1	………

Fig. 8-2

A

ø18 mm

ø12 mm

Roll paper core

Fig. 8-3

4Determine the diameter of the roll paper you are using and find the required setting in the table below.

Distance A	Setting	Indicator
Approximate 9 mm	Level 3	ooo
Approximate 7 mm	Level 2	oo
Approximate 5 mm	Level 1 *1	o

*1 Cannot be used with 2 and 3 ply.

Note:

1.Since the distance A correspond- ing to the adjustment position on the chart is a calculated value, there may variations due to the actual mechanism.

2.If there is an end mark at the end of a roll of paper, that end mark is an adhesive that may lift the entire roll of paper. In such a case, the remaining roll paper amount (Distance A) shown in the chart above will not apply.

3.The quality of some paper may cause it to become jammed. This can result in erroneous detec-

tion.

5Insert the tip of a ballpoint pen or similar pointer object into the hole of the adjuster. While pressing the

adjuster, slide it up or down to the

Asetting you that matches the roll

paper you are using.

6Make sure the tab indicated by the arrow in the illustration is inside one of the grooves.

– 31 –