– 9 –
Loading the Paper (Tear Bar Model)1Lift the cover up approx. 3cm. Hold the cover
tilted at this angle, then pull it toward you to
remove it.
2Cut off the front edge of the roll paper
perpendicularly.
3Confirm that the power of the printer is turned
on.
4While observing the direction of the roll paper,
insert the top end of the paper beneath the paper
guide as far as it will go. If the roll paper is installed,
the top end of the paper automatically comes out
from the paper exit.
5Move the paper roll holder in the direction of the
arrow, and insert the roll so that the holes in the
core align with the axes of the paper roll holder.
Release the paper roll holder to secure the paper.
6If the paper roll core has not been properly
aligned with the paper roll holder, the cover
cannot to properly seated until the paper position
is corrected.
7Press the FEED (paper feed) switch to feed the
paper approximately 10cm.
8Insert the top edge of the paper into the tear bar
slot, then mount the cover by reversing the
procedure for removing the cover in step 1
above.
Note: When the paper end mark appears on the
paper, replace the roll paper before it runs
out.
Cover
FEED
switch
Roll paper
Core
Axis
Paper roll holder
Roll paper
Cover
Positioning rib
Paper roll holder
Tear bar
FEED switch