– 6 –
ON LINEPOWER FEED
3
POWER lamp (Green LED)
4
ON LINE lamp (Green LED)
1
ON LINE switch
2
FEED switch
Control Panel
1ON LINE switch
Switches the printer between ON LINE and OFF LINE.
ON LINE and OFF LINE switching is possible only
when paper is loaded in the printer.
2FEED switch
•When this switch is pressed and then released within
0.5 sec., the paper feeds on line.
•When this switch is held depressed for more than 0.5
sec., the paper feeds continuously.
(The above paper feed operation is possible for both
ON LINE and OFF LINE modes.)
3POWER lamp (green LED)
•Lights when the power to the printer is on.
•Flashes when paper is out, mechanical error occurs, when there is an alarm due to head
temperature detection, or when a CPU error has occurred.
•If the paper is out, load new paper and press the ON LINE switch.
•When the POWER lamp flashes due to occurrence of a mechanical error, turn off the power and
remove the cause of a mechanical error and then turn on the power again to reset the printer.
•If the POWER lamp flashes due to the alarm of the head temperature detection, the printer will
be set automatically when the head temperature becomes low.
4ON LINE lamp (green LED)
LED lit: Printer is ON LINE
LED off: Printer is OFF LINE
LED flashes: CPU error
When the POWER lamp and ON LINE lamp light simultaneously, a CPU error has occurred.
Loading the Ribbon Cartridge (Tear Bar Model)
1Turn off power to the printer.
2Lift the cover up approx. 3 cm. Hold the cover
tilted at this angle, then pull it toward you to
remove it.
Cover
Power off