4. Attaching the Accessories

4-1. Attaching the Holder Plate

(1) Attach the holding plate to the printer. Then tighten the two screws that were supplied to secure it in place.

(2) Position the printer over the wall bracket and then slide it downward to set it in place.

The printer is fixed in place by inter- locking the hook on the plate at- tached to the bottom of the printer with the hook connector on the bracket. It is not necessary to secure it further with screws. To purchase a bracket, which is sold separately, please contact your dealer.

(3) Push the cover open lever, and open the printer cover.

(4) Insert the roll paper as shown.

– 13 –

Page 16
Image 16
Star Micronics TSP100 manual Attaching the Accessories, Attaching the Holder Plate