Star Trac E-TBT manual Assembly and Setup, Tools Required, Unpacking and Assembly

ASSEMBLY AND SETUP

Use the following procedures to unpack and assemble your STAR TRAC E SERIES TOTAL BODY TRAINER.

TOOLS REQUIRED

■Hex (Allen) Key, 3/16-inch

■Hex (Allen) Key, 5 mm

■Screwdriver, Phillips #2

UNPACKING AND ASSEMBLY

1. Unpack the Shipping Carton

Remove the top and sides of the shipping carton.

Remove the display box and upper body arms and set aside

Remove the remaining foam packing inserts and the protective bagging from the

Total Body Trainer.

2. Install the Display

Take the 3 cables that are coming out of the lower neck and feed them through the upper neck through the hole provided. Make sure you hold the cables as you insert the upper neck into the lower neck.

After inserting the neck, make sure the cables are not pinched between the 2 sec- tions of the neck.

Install (2) 5/16-18 x 3/4” Button Head Screws into the front of the neck, use a 3/16 hex key to tighten the screws to 200 lb-in (23 N-m) of torque..

Bolt

Secure the neck by tightening the 3/8-16 x 2” Socket Head Cap Screw using a 5/16” hex key. Tighten bolt to 300 lb-in (34 N-m).

STAR TRAC E SERIES TOTAL BODY TRAINERS OWNER’S MANUAL 11