ASSEMBLY AND SETUP
Use the following procedures to unpack and assemble your STAR TRAC S SERIES TREADMILL. Assembly procedures are the same for all S SERIES TREADMILLS.
UNPACKING
Open the shipping carton, remove all parts from the carton and foam inserts, and verify that the following parts are included in your shipment:
Description | Qty | Description | Qty |
Base Assembly | 1 | Lockwasher, D=10 | 8 |
Neck (and Shroud) | 1 | Hex Nuts* | 4 |
Neck Shroud | 1 | Bolt, Allen Head, M6 X 50 | 4 |
Display Console Assembly | 1 | Screw, Hex Head, M10 X 140** | 4 |
Handrail | 2 | Bolt, Allen Head, M6 X 25 | 2 |
Bolt, Allen Head, M10 X 20 | 8 | Lockwasher, D=6 | 4 |
*Used for shipping only.
TOOLS REQUIRED
Most STAR TRAC treadmills can be assembled using the following tools:
∙ Metric Hex Key Wrenches | ∙ | Channel Lock Pliers | |
∙ | Metric | ∙ | Vice Grip Pliers |
∙ Metric Ratchet Socket Wrench Set | ∙ | Rubber Mallet | |
∙ | Torque Wrench | ∙ | Phillips Head Screwdriver |
Your STAR TRAC S SERIES TREADMILL includes a hex key set and combination
ASSEMBLY
1. Unpack and Position the Base Assembly
CAUTION: The motor end of the base assembly is very heavy. Two people may be needed to lift this end when moving the base assembly.
Remove all packaging material so the base assembly is sitting on the shipping crate platform. With a helper, lift the base assembly from the shipping crate platform, and place it in the location where it will be used. Be sure the selected location is level, and close to a power outlet.
3. Install the Display Console
STAR TRAC S SERIES TREADMILLS OWNER’S MANUAL | 19 |
