Poor TV reception

Problem

•Check the input signal cable, make sure it is in good shape and is connected snug to the RF input.

•Try a new channel; it may be the station is having difficulties.

•Check for local interference.

•Try adjusting the Sharpness in the PVS video setup.

Ghost in the picture	Check the input signal cable, make sure it is in good shape and is connected snug
•

Missing TV Channels

to the RF input.

• Try a new channel; it may be the station is having difficulties.

• Check for local interference.

• Check the Channel setup of the PVS. The specific channel may not be pro- grammed. If necessary, rerun the Auto Scan feature in Channel Setup.

Lost Password

• These channels may be blocked, please unblock them (see Setting Parental Con- trols section).

• These channels may be set hidden. You may set it to show or select them with 0-9 number buttons (See channel Editor section).

• You may use the super password (2580) to access the Parental Controls menu and set a new password.

Center console key- pad seems unre- sponsive

•Check to see that the ribbon cables are connected firmly and properly (ribbon may be reversed).

•Check center console PC board LED (will be green or red), if there is no light on the center console, it is not receiving any power.

•Unplug power supply from base of equipment, then plug it back

“No Signal” dis- played on screen.

•See “NO PICTURE”, You may have to rerun the setup routine for the display.

•Check that all input values are correct for you service provider.

•Press the ‘7’, ‘8’, and ‘9’ buttons simultaneously to change from AV input to RF in- put.

Programme Edit function not available

(PAL system only)

If the Programme Edit feature becomes unavailable, follow these steps to restore function:

•Press VOL-, CH- and number [3] at the same time to enter TV configuration mode, (TV icon LED starts blinking).

•Press VOL-, CH- and number [4] to enable Programme Edit feature, (new configu- ration saved to memory).

•Press VOL-, CH- and number [6] at the same time to exit TV configuration mode, (TV icon LED stops blinking).

Note: After 30 seconds from last key press, the system will automatically exit TV con- figuration mode.

Note: If your problem is not solved, turn your unit off and then on again.

Caution: Never attempt to repair a defective TV yourself.

For technical assistance call Star Trac Customer Service: 1 800 503 1221

39	620-7992 Rev 001

Star Trac S-RBX, S-UBX manual Poor TV reception