Sterling 1-Pump 5-Station Controller service manual Using the Controller, Introduction, Setup

5 Using the Controller

5-1 Introduction

This chapter gives the procedures for configuring your

SSC1-5Q controller.

Configuration of your SSC1-50Q controller includes setting the number of stations, setting variables such as convey time and blow-back interval. Sterling recommends that you carry out these procedures in the order given here.

5-2 Setup

Important! Before carrying out these procedures, install all equipment as described in Chapter 4: “Installation”, and in the manual SPD/SPC Series Conveying Systems.

5-2-1 Setting Up the System

This section provides an overview of the controller screens used in configuring the system. Section 6 provides a detailed explanation of the features listed on each screen.

5-2-1-1 Basic Menus and Setup of Controller

Once power has been applied to a properly installed system, turn the disconnect switch to the ON position. The alpha controller will display the screen for receiver 1 (Hopper 1).

Page 21 of 38