Filling the Unit
Fill the water tank with water by opening valves e and f. Valves c, d, g, and h are automatically controlled by a timer. After you open valves e and f, water flows and is filtered in the normal direction.
Take a moment now, while the filter is clean, to record pressure gauge readings at the inlet and outlet of the filter. You’ll use these readings later to determine the cleanliness of the filter media.
Complete the installation of the sand and gravel filter by plugging the unit into a
3-2 Installing the Centri-Separator System
Selecting an Installation Site
Place the unit on a suitable and level foundation, preferably a concrete floor or pad and near the pump for best operation. The location you select must also have an open drain to a sewer for purging and a
Use a fork lift truck when moving the unit to avoid damage.
Installing Piping
Be sure that piping to the unit has a bypass circuit. The bypass circuit allows for removal of the unit for servicing without interrupting water service. Part of your
Priming the Pump and Preparing for Operation
Be sure that the pump on your
Water Management Systems and Products | Page 11 |