Complete the installation of your
3-3 Installing the BFS Series Bag Filter
Selecting an Installation Site
Place the unit on a suitable and level foundation, preferably a concrete floor or pad and near the pump for best operation.
Use a fork lift truck when moving the larger units to avoid damage.
Installing Piping
Be sure that piping to the unit has a bypass circuit. The bypass circuit allows replacement of bag filter without interruption of service. Connect to the inlet and outlet as labeled on filter housing. Solids will collect inside the bag filter preventing spill over when the bag is removed. Always run piping full size. Filter housing maximum operating pressure is 150 psi.
Selecting an Installation Site
Place the unit on a suitable and level foundation, preferably a concrete floor or pad and near the pump for best operation.
Use a fork lift truck when moving the larger units to avoid damage.
Installing Piping
Be sure that piping to the unit has a bypass circuit. The bypass circuit allows for removal of the unit for servicing without interrupting water service. Connect to the inlet and outlet as labeled on the housing. Solids will collect in the bottom of the housing where it will be purged out of the system. Always run piping full size. Filter housing maximum operating pressure is 100 psi.
Page 12 | Water Management Systems and Products |